Part Number:

P-7100 Upgraded Pump Camshaft V3 - OUT OF STOCK







The V3 STANDARD ROTATION P-7100 pump cam is made in the USA out of 8620 gas carburized steel. The V-3 is the pump cam that is the fastest at .0181" per degree. To get the faster rate, we had to add lift so it is .510" lift whereas all other cams are .472" lift. 

IMPORTANT NOTE - This cam needs to be installed by qualified professionals only. To make them fit, you have to clearance the inside of the case but most pump shops are willing to do this to get the extra power. When doing a performance pump cam in your P-7100, we recommend to use upgraded pump springs to aid in keeping the roller in contact with the cam at higher rpm.

All of our pump cams are for off-road use only. Buyer accepts all liability for their use. P-pumps in performance applications can occasionally stick the rack, which allows the pump to keep fueling until there is a loss of air via an air-shutoff, until the mechanical limits of the motor are reached, or you run out of road.  Installation needs to be handled by an experienced pump builder with the proper tools and test equipment.

Rule of thumb for where to set LPC or lift port closure.

  • 0-14mm of maximum rack travel (2.6  and 3.0 puller etc) LPC 4.75mm

  • 14mm-16mm of rack travel  LPC 4.5mm


  • Fuel Type: Diesel
  • Condition: New
  • Not For Sale In California

    CALIFORNIA WARNING: Cancer and Reproductive Harm -

    Additional Information

    Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur.

    Curabitur augue
    • sollicitudin mauris
    • Pellentesque mauris
    • sollicitudin consectetur
    • reprehenderit augue